Handling; Final Positions - SCHUNK KLM Series Assembly And Operating Manual

Handling

6 Handling

6.1 Final positions

24
03.00 | KLM | Assembly and operating manual | en | 389173
CAUTION
The end plates are mounted at the factory so that the fitting
bores Intermediate stops
tolerance of ±0.01 mm! After mounting by the customer of the
intermediate stop Intermediate stops
Dust cover [ 27] and the anti-fall device
}
customer must ensure/set the tolerance, if necessary.
Orientation of the end plates
The following components are available for stroke limitation,
damping and monitoring of end positions:
• LMAS-... (stop screw)
• LMST-... (shock absorber stop)
• LMNS-... (proximity switch)
Use the stop screw LMAS-... only for short strokes, slow stroke
speeds and low kinetic energy!
Shock absorber stops (LMST-...) must be used as standard!
The following diagram shows the installation of LMST -... and
LMNS -... using installation variant 1 (interior).
If installation variant 2 (exterior) is used, the actuating pin and
damping adjustment are interchanged with LMST -... and LMNS
-.... (does not apply to KLM 25)
[ } 26] are aligned to dimension with a
[ 26] the dust covers
}
Rod lock [ 27] the
}