Pneumatic Connection - SCHUNK KLM Series Assembly And Operating Manual

Assembly

4.3.2 Pneumatic connection

20
03.00 | KLM | Assembly and operating manual | en | 389173
WARNING
Risk of injury due to unexpected movements!
If the power supply is switched on or residual energy remains in
the system, components can move unexpectedly and cause
serious injuries.
Before starting any work on the product: Switch off the power
•
supply and secure against restarting.
Make sure, that no residual energy remains in the system.
•
NOTE
• Observe the requirements for the air supply
• Operation is possible without restrictions with oiled or unoiled
compressed air.
• Use connecting pipes of a cross-section that is larger than or
identical to that of the connector thread.
• Before installing connecting cables, remove dust, dirt or
particles by blowing the equipment.
• Avoid penetration of sealant into the pipeline network.
• Take the pneumatic components just before mounting out of
the packaging.
Location of air connections
Thread diameter of the air connections
Size
Hose connection
A = Linear unit of extend
B =Linear unit of retract
Technical data
25 50 100
M5 M5 G1/8"
[ 15]
}
300
G1/4"