Alarm In - Provision ISR IP Series User Manual

Page 22
communication by the camera. After the setting is complete, click "Save".

4.3.4 Alarm In

Enter "Alarm" "Alarm In" to see a screen as shown below:
→
2. Enable the alarm to activate it and see the configuration parameters:
Parameter
Alarm Type
Alarm Holding Time
Sensor Name
Alarm Out
Trigger Snap
Trigger Email
Trigger FTP
3. After the setting is complete, click "Save".
IP CAMERA USER MANUAL
Meaning
You can set it to "NO" (Normally open) which means
that the once the line is closed the alarm will be active,
or "NC" (Normally Closed") which means that once
the line is open the alarm will be active.
The holding time means that the alarm signal will stay
active and no additional alarms will be generated
during that time.
You can set a unique name for easy identification.
Alarm Triggers:
triggers the alarm out relay
takes a snapshot (SD card must be available)
sends an email as configured in the Email section.
send a snapshot as configured in the FTP section