Provision ISR IP Series User Manual page 38

Page 33
Please note:
1) In order for the DHCP mode to work, you must have a DHCP server on the LAN.
2) Using DHCP for permanent installations is not advisable as the IP Address might
change after a while and cause the camera to be unreachable.
Manual IP Assignment: If you wish to set static IP addresses, choose "Use the following IP
Address", set the range of IP addresses you wish to assign (First and last address), set the
gateway and subnet mask and click on batch set. Wait for a few moments until the IP manager
will configure the cameras. After configuration, the IP addresses of the cameras will refresh
automatically.
Please note:
1) The selected IP address must be available.
The next tab is IPv6:
If you need to use IPv6, configure it in the same method as described for IPv4.
The next tab is PPPoE:
For PPPoE, the user is required to manually input the username and password for dial-up
internet. After saving the username/password information set up IP address change
notification. Last, connect with Modem and the device will dial-up internet automatically.
Press the "Save" button to save the settings.
IP CAMERA USER MANUAL