Mask Detection; General Fault - Provision ISR IP Series User Manual

Page 19
Alarm Out 1/2
Trigger Audio Alarm
Trigger SD Snap
Trigger SD Recording
Trigger Email
Trigger FTP

4.3.2 Mask Detection

In this interface you can set the EC-001 detection and response to face masks.
Enable the alarm if required and set the alarm triggers.
The holding time means that the alarm signal will stay active and no additional alarms will be
generated during that time.
Choose the camera's response to the alarm:
Alarm Out 1/2
Trigger Audio Alarm
Trigger SD Snap
Trigger SD Recording
Trigger Email
Trigger FTP

4.3.3 General Fault

A problem with the network cable or with the SD card will produce a general fault. The
alarms can be configured as follows: SD Card Full, SD Card Error, IP Address Conflict,
Network cable disconnected.
Enter "Alarm Configuration"
IP CAMERA USER MANUAL
Alarm Triggers:
triggers the alarm out relay
Sound the corresponding alarm audio using the
built in speaker.
takes a snapshot (SD card must be available)
Initiates video recording over the SD card (SD card
must be available)
sends an email as configured in the Email section.
send a snapshot as configured in the FTP section
Alarm Triggers:
triggers the alarm out relay
Sound the corresponding alarm audio using the
built in speaker.
takes a snapshot (SD card must be available)
Initiates video recording over the SD card (SD card
must be available)
sends an email as configured in the Email section.
send a snapshot as configured in the FTP section
"General Faults" to see a screen as shown below. The default
→