View The Access Point Internet, Ip, And System Settings - NETGEAR WAX610 User Manual

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
View the access point Internet, IP, and system
settings
To view the access point, Internet, IP, and system settings:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 37.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight app on page 22.
The Dashboard page displays.
4. Locate the Connection Status Information pane, System Information pane, and IP
Settings Information pane, which are shown, respectively, on the left, upper center,
and lower center of the following Dashboard figure.
(If the page width on your device is narrow, these panes might be located elsewhere
on the Dashboard.)
Monitor the Access Point and the
Network
168 User Manual