View A Wifi Bridge Connection - NETGEAR WAX610 User Manual

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
• Target. The name, IP address, or MAC address of a target device, application,
or website, if applicable.
5. To save the logs, do the following:
a. Click the Save button.
b. Follow the directions of your browser to save the file to your computer.
6. To download the detailed log entries, do the following:
a. Click the Download Detailed Logs button.
Depending on the size of the file, downloading the detailed log entries might
take several minutes.
b. Follow the directions of your browser to save the file to your computer.
7. To refresh the log entries onscreen, click the Refresh button.
WARNING: After you clear the log entries, you can no longer save or download
them.
8. To clear the log entries, click the Clear button.

View a WiFi bridge connection

You can configure a wireless distribution system (WDS) that consists of point-to-point
WiFi bridge connections between two access points (see Set up a WiFi Bridge on page
188). This is different from a NETGEAR Insight Instant Mesh WiFi network.
You can view whether a WiFi bridge is established and view the function (base station
or repeater), MAC addresses, and IP addresses of the access points that form the WiFi
bridge.
To view a WiFi bridge connection:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 37.
3. Enter the access point user name and password.
Monitor the Access Point and the
Network
185 User Manual