NETGEAR WAX610 User Manual page 17

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
• Do not spill food or liquids on your product components, and never operate the
product in a wet environment. If the product gets wet, see the appropriate section
in your troubleshooting guide, or contact your trained service provider.
• Do not push any objects into the openings of your product. Doing so can cause fire
or electric shock by shorting out interior components.
• Use the product only with approved equipment.
• If applicable to your product, allow the product to cool before removing covers or
touching internal components.
• Be sure that devices that are attached over Ethernet cables are electrically rated to
operate with the power available in your location.
• Depending on your product, use only the supplied power adapter or an Ethernet
cable that provides PoE.
If your product uses a power adapter:
- If you were not provided with a power adapter, contact your local NETGEAR
reseller.
- The power adapter must be rated for the product and for the voltage and current
marked on the product electrical ratings label.
• To help prevent electric shock, plug any system and peripheral power cables into
properly grounded power outlets.
• If applicable to your product, the peripheral power cables are equipped with
three-prong plugs to help ensure proper grounding. Do not use adapter plugs or
remove the grounding prong from a cable. If you must use an extension cable, use
a three-wire cable with properly grounded plugs.
• Observe extension cable and power strip ratings. Make sure that the total ampere
rating of all products plugged into the extension cable or power strip does not
exceed 80 percent of the ampere ratings limit for the extension cable or power strip.
• To help protect your system from sudden, transient increases and decreases in
electrical power, use a surge suppressor, line conditioner, or uninterruptible power
supply (UPS).
• Position system cables, power adapter cables, and PoE Ethernet cables carefully.
Route cables so that they cannot be stepped on or tripped over. Be sure that nothing
rests on any cables.
• Do not modify power adapters, power adapter cables, or plugs. Consult a licensed
electrician or your power company for site modifications.
• Always follow your local and national wiring rules.
Hardware Overview 17 User Manual