NETGEAR WAX610 User Manual page 36

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
(Continued)
Setting Description
AP Name As an option, enter a new name for the access point. The name must contain alphanumeric
characters, must contain at least one alphabetical character, cannot be longer than 15
characters, and can contain hyphens but cannot start or end with a hyphen.
By default, the access point name is Netgearxxxxxx, in which xxxxxx represents the last six
hexadecimal digits of the access point's MAC address.
AP Login New Enter a new admin password. This is the password that you must use to log in to the access
Password point's local browser UI. (It is not the password that you use for WiFi access.)
The password must be 8 to 63 characters in length and must contain at least one uppercase
letter, one lowercase letter, and one number. The following special characters are allowed:
! @ # $ % ^ & * ( )
Save the password for future use.
Confirm New Enter exactly the same password that you entered in the AP Login New Password field.
Password
SSID You cannot use the default SSID for regular operation. The default SSID is for setup only.
Enter a new name with a maximum of 32 characters. You can use a combination of
alphanumeric and special characters, except for quotation marks (") and a backslash (\).
Authentication From the menu, select one of the following authentication types for the WiFi network:
• Open. Authentication is not required and data encryption is not supported. This setting
• WPA2 Personal. This option allows only WiFi clients that support WPA2 to connect to
• WPA2/WPA Personal. This option allows both WPA and WPA2 WiFi clients to connect
After you complete the setup process, you can set up WPA3 Personal, WPA3/WPA2
Personal, or WPA2 Enterprise security with RADIUS servers. For more information, see
Change the authentication and encryption for a WiFi network on page 61.
Passphrase Unless you selected Open from the Authentication Type menu, enter a new passphrase
(network key or WiFi password) for the WiFi network.
9. Click the Apply button.
Your settings are saved. A pop-up window displays the IP address and the new WiFi
network and password (passphrase).
Install the Access Point in Your
Network and Access It for Initial
Configuration
does not provide any security and is not appropriate for most situations.
the SSID. Select this option if all WiFi clients are capable of supporting WPA2. This
option uses AES encryption.
to the SSID. This option uses TKIP and AES encryption. Broadcast packets use TKIP. For
unicast (that is, point-to-point) transmissions, WPA clients use TKIP and WPA2 clients
use AES.
36 User Manual