Enable Or Disable Ethernet Lldp - NETGEAR WAX610 User Manual

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
The Dashboard page displays.
4. Select Management > Configuration > System > Advanced > General.
The General page displays.
5. Select an IGMP Snooping radio button:
• Enable. IGMP snooping is enabled.
• Disable. IGMP snooping is disabled. This is the default setting.
6. Click the Apply button.
Your settings are saved.

Enable or disable Ethernet LLDP

Link Layer Discovery Protocol (LLDP), as specified in IEEE 802.1AB, can provide link-layer
messages to adjacent network devices. For example, LLDP lets network devices such
as switches and management devices discover the access point in a network.
LLDP can also detect if the access point receives power through PoE. By default, LLDP
is enabled.
To enable or disable the LLDP:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 37.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight app on page 22.
The Dashboard page displays.
Manage the Local Area Network
and IP Settings
137 User Manual