Akuvox Smart Intercom R29 Series Admin Manual page 90

R29X
Admin Guide
4.4.2. Motion
4.4.2.1. Motion in device
In the phone interface, go to Motion to configure. By enabling the
motion detection function, the door phone will detect and record any
change in the surrounding, such as suspicious people loitering
around, and send notification message to a monitor unit.
Timing setting
If users only enable time mode and setup the interval. R29 series
will take the picture in every interval time;
Only enable detection mode, R29 series will capture if there is any
change of surrounding in the detection time;
Enable timing mode and detection mode in the same time, if there
is no any change of surrounding, R29 series will capture in the
interval time. Otherwise, the device will take the picture in detection
mode.
79
Figure 4.4.2.1 Motion