Control Over Printing Quality - Flashforge Inventor II User Manual

needed. Press down the left mouse button and drag to generate the support.
2）Manual Delete
7-11
Like the picture above, a hole inside the model doesn't need any supports.
Left click the [Delete] button and then left click the supports needed deleting. And the
support will be deleted.

7.2 Control over Printing Quality

①
Enhance the build plate adhesiveness
● Leveling the build plate
● Keeping the build plate smooth and tidy
● Using the build tape or glue
②
Adjusting the printing speed
● Low (Fast) (Print Speed 80mm/s Travel Speed 100mm/s)
● Standard (Print Speed 60mm/s Travel Speed 80mm/s)
● High (Slow) (Print Speed 50mm/s Travel Speed 70mm/s)
● Hyper (Print Speed 50mm/s Travel Speed 70mm/s)
7.3 Skills of Model Placement
Not all the models are in the right positions after being loaded. Therefore, you need to
Inventor Ⅱ User Guide | www.flashforge.com
0086-0579-82273989
73