Flashforge Inventor II User Manual page 49

5.2.14 Tool Menus
①Control Panel
After connecting PC with InventorⅡ, click [Tools]--[Control Panel] to open the
control panel.
5-23
● Jog Controls
a. Jog Mode： Select the distance that extruder/ build plate move a single time (that is,
the distance extruder/ build plate move upon your single click).
b. Six blue arrow direction button: Control the move along X/Y/Z axis. X/Y axis
button control extruder move, Z axis button control build plate move. Click X-,
extruder will move leftward a specified distance; Click X+, extruder will move a
specified distance rightward. Click Y-, extruder will move forward a specified distance;
Click Y-, extruder will move backward a specified distance. Click Z-, build plate will
move upward a specified distance; Click Z-, build plate will move downward a
specified distance. (Specified distance refers to the move distance you set in Jog
Mode.
c. Stop: Click the [stop] button to abort the current movement. d. XYZ coordinate
frame on the right side: Show the current position of extruder/build plate.
Inventor Ⅱ User Guide | www.flashforge.com
0086-0579-82273989
49