Flashforge Inventor II User Manual page 46

Method 1：Connect Via USB Cable
a. Connect your InventorⅡ with your PC via an USB cable.
b. Turn on your InventorⅡ and start Flashprint.
c.Click [Print]--[Connect
option and select machine you want to connect in
not find your machine, click the
Finally click [Connect] button to connect to the printer. If you still can not find your
machine after rescan, it means you haven't installed the driver in the software.
Method 2： Connect Via WIFI
①
Connect InventorⅡ with your PC under AP mode
a.Turn on your InventorⅡ
b.Tap [Tools]-[Setting]-[WIFI]-[WIFI ON]
c. Click on the wireless network on the left bottom, and find the wireless
signal-"InventorⅡ". Click [Connect] to finish network connection.
d. Click[Print]-[Connect Machine] on Flashprint. Then the following dialog box
pops up. You need to select "Wi-Fi" in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].
Inventor Ⅱ User Guide | www.flashforge.com
Machine], then select USB in the
[Select Machine]
[Rescan] button to scan your machine and select it.
5-18
46
[Connection Mode]
option. If you can
0086-0579-82273989