Flashforge Inventor II User Manual page 23

3-12
℃
(3-12) After the extruder reaches 220 , the printer will sound a beep to prompt you to
unload the filament from the extruder. Press the spring presser, press down the
filament for about three seconds and gently pull the filament out.
Note: Do not pull out the filament with force as it will damage the gears. If the
melted filament has cooled down in the extruder, please repeat the steps above.
Inventor Ⅱ User Guide | www.flashforge.com
0086-0579-82273989
23