Flashforge Inventor II User Manual page 36

5.2.7
Scale
Select the target object and scale the object by the following two methods:
Method 1: Click the [Scale]
scale the model. The corresponding values will display near the object.
Method 2: Click the [Scale]
axes positioning. Click the
Click [Reset] to reset the size of model.
Note: If the [Uniform Scaling]
proportion when changing
only change the value of the corresponding positioning.
5.2.8
Cut
Left-click on the model to select it and double-click on the Cut icon to set the cut
plane. The direction and position are available for setting.
①
Draw with Mouse
②
X Plane
Inventor Ⅱ User Guide | www.flashforge.com
icon on the left, hold down the left mouse button and
icon on the left and then enter into scale values in X/Y/Z
[Maximum] button to get largest size possible for building.
radio button is clicked, it will scale the model in equal
value in any positioning of the model. Otherwise it will
36
0086-0579-82273989