Flashforge Inventor II User Manual page 58

6.2.3 Print from USB Flash Disk
①Insert your USB flash disk with target .g or .gx file to your InventorⅡ.
②Turn on the InventorⅡ. Make sure the build plate has been leveled and the filament
is loaded.
③Tap
[Print] and then tap the SD Card icon in the middle. The file(s) will be
displayed on the screen. Select the file you want to print and tap [Print]. The file will
be transferred to the printer.
⑥And the printer will heat up the nozzle automatically and start to print after the
nozzle reaches the aimed temperature.,
Abort：To stop heating and printing. Once you tap [Abort], the process is irreversible.
Pause：To suspend the print job, you can tap it again to resume it. You can use this
function when you want to change the filament halfway.
Inventor Ⅱ User Guide | www.flashforge.com
0086-0579-82273989
58