Adjusting Clutch Pedal; Adjusting Parking Brake; Adjusting Shift Cables - Toro Workman 3100 Operator's Manual

3
Figure 42
1. Brake pedal
2. Clutch pedal

Adjusting Clutch Pedal

Check adjustment every 200 hours.
1. Loosen jam nuts securing clutch cable to bracket on bell
housing.
Note: Ball joint may be removed and rotated, if additional
adjustment is required.
2. Disconnect return spring from clutch lever.
4
3
Figure 43
1. Clutch cable
2. Jam nuts
3. Adjust jam nuts/or ball joint until bottom rear edge of
clutch pedal is 3.75" + .12" from top of floor plate
diamond pattern, when an 4 lb. force is applied to pedal.
Note: Force is applied so release bearing lightly contacts
pressure plate fingers.
4. Reconnect return spring to clutch lever.
2
1
3. Clutch pedal upstop
1
2
3. return spring
4. Ball joint
5. Verify that rear edge of clutch pedal is 5.5" + .12" from
top of floor plate diamond pattern. If dimension is not
attained, adjust clutch pedal upstop.
Note: The clutch free play should never be less than .75".
6. Tighten jam nuts after adjustment has been attained.
7. Recheck clutch safety switch adjustment (Fig. 44).
Engine must not crank unless clutch pedal is
1.25" .12" from floor. If an adjustment is required,
loosen switch jam nuts and adjust up or down.
1. Clutch switch

Adjusting Parking Brake

Check adjustment every 200 hours.
1. Loosen set screw securing knob to parking brake lever.
2. Rotate knob until a force of 35–45 lbs. for 2 wheel drive
or 45–55 lbs. for 4 wheel drive is required to actuate
lever.
3. Tighten set screw after adjustment has been attained.
3
2
1. Parking brake lever
2. Knob

Adjusting Shift Cables

Check adjustment every 200 hours.
1. Move shift lever to Neutral position.
41
1
Figure 44
1
Figure 45
3. Set screw