Adjusting The Brake Cables - Toro Workman 07235 Operator's Manual

required to engage the parking-brake lever,
perform the procedure for adjusting the brake
cables; refer to

Adjusting the Brake Cables

(page 51).
4. Tighten the set screw and install the hand grip
(Figure 65).
Adjusting the Brake Cables
1. Remove the hand grip from the parking brake
(Figure 65).
2. Loosen the set screw
brake-adjustment knob to the parking-brake
lever, disengage the parking brake, and loosen
the brake-adjustment knob.
3. At the bottom of the machine, loosen the
rear-jam nut for the threaded adjuster of the
parking-brake cable 4 turns
1. Forward-jam nut
2. Rear-jam nut
3. Brake-cable bracket
4. Tighten the forward jam nut
5. Rotate the brake-adjustment knob
until a force of 133 to 156 N∙m (30 to 35 ft-lb) is
required to engage the parking-brake lever.
•
If you cannot adjust the brake-adjustment
knob by loosening it and engage the
parking-brake lever with a a force of 133
to 156 N∙m (30 to 35 ft-lb); perform the
following:
A. Loosen the forward-jam nut
66) for the threaded adjuster of the
parking-brake cable 1 turn.
B. Tighten the rear jam nut
C. Rotate the brake-adjustment knob
(Figure 65) until a force of 133 to
156 N∙m (30 to 35 ft-lb) is required to
engage the parking-brake lever.
(Figure 65) securing the
(Figure 66).
Figure 66
4. Threaded adjuster
(parking-brake cable)
5. Front of the machine
(Figure 66).
(Figure
(Figure
(Figure
D.
•
If you cannot adjust the brake-adjustment
knob by tightening it and engage the
parking-brake lever with a a force of 133
to 156 N∙m (30 to 35 ft-lb); perform the
following:
A.
B.
C.
D.
Note:
cable enough to get the brake-adjustment
knob within its adjustment range, check the
brake pads for excessive wear.
•
Tighten the set screw and install the handgrip
(Figure
g029672
65)
66).
51
Repeat steps A through
times to attain the parking brake force
between 133 to 156 N∙m (30 to 35 ft-lb).
Loosen the rear-jam nut
66) for the threaded adjuster of the
parking-brake cable 1 turn.
Tighten the forward jam nut
Rotate the brake-adjustment knob
(Figure 65) until a force of 133 to
156 N∙m (30 to 35 ft-lb) is required to
engage the parking-brake lever.
Repeat steps A through
times to attain the parking brake force
between 133 to 156 N∙m (30 to 35 ft-lb).
If you cannot adjust the parking-brake
65).
C up to 2 more
(Figure
(Figure 66).
C up to 3 more