Checking The Brake Fluid Level; Checking The Engine-Oil Level - Toro 07359 Operator's Manual

Hide thumbs Also See for 07359:
Table of Contents

Advertisement

Note: Shut off the engine and allow all moving parts to
stop before checking for oil leaks, loose parts, and other
wear and damage.
If any of the above items are not correct, notify your
mechanic or check with your supervisor before taking the
machine out for the day. Your supervisor may want you to
check other items on a daily basis, so ask him or her about
additional operator's responsibilities.
Checking the Brake Fluid
Level
Service Interval: Before each use or daily Check the
brake-fluid level before the motor is first
used.
Brake Fluid Type: DOT 3
1. Park the machine on a level surface, set the parking
brake, rotate the On/Off switch to the Off position,
and remove the key..
2. Remove the rubber plug in the center and on top of
the dash to gain access to the master brake cylinder
and reservoir
(Figure
Figure 13
1. Rubber plug
2. Reservoir cap
3. Look at the outline of the fluid level at the side of the
reservoir.
(Figure
14).
Note: The level should be above the Minimum line
13).
3. Filler neck (reservoir)
4. DOT 3 brake fluid
1. Brake-fluid reservoir
4. If the fluid level is low, preform the following:
A. Clean the area around the reservoir cap, and
remove the cap
B. Add DOT 3 brake fluid to the reservoir until the
fluid level is above the Minimum line
Note: Do not overfill the reservoir with brake
fluid.
C. Install the reservoir cap
5. Install the rubber plug in top of the dash

Checking the Engine-Oil Level

Service Interval: Before each use or daily Check the oil level
in the engine before the engine is first
started.
Note: The machine is shipped with oil in the crankcase;
however, check the oil before and after you start the engine.
Oil Type: Detergent oil (API service CH-4, CI-4, CJ-4, or
higher)
Viscosity: See the table below
F -30
10
-10
C -34
-23
-12
STARTING TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
* A synthetic 5W -30 oil may be used.
1. Move the machine to a level surface.
2. Raise the cargo box; refer to
(page
17).
3. Use a rag to clean around the oil dipstick
that dirt cannot fall into the dipstick tube and damage
the engine.
19
Figure 14
2. Minimum line
(Figure
13).
(Figure
(Figure
13).
(Figure
15W-40
10W-30
5W-30
32
50
70
90
0
10
21
32
G017503
Figure 15
Raising the Cargo Box
(Figure
14).
14).
110
43
16) so

Advertisement

Table of Contents
loading

This manual is also suitable for:

07359tcWorkman mdx-d

Table of Contents