Specifications; Attachments/Accessories; Operation; Checking The Engine-Oil Level - Toro 07379 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Dimensions
Overall Width 160 cm (63 inches)
w/o bed: 326 cm (128.25 inches)
w/full bed: 331 cm (130.38 inches)
Overall Length
w/2/3 bed in rear mounting location:
346 cm (136.38 inches)
Base Weight (Dry) 819 kg (1806 lb)
Rated Capacity
(includes 200 lb.
operator, 200 lb. 1381 kg (3044 lb)
passenger and loaded
attachment).
Maximum. Gross
2200 kg (4,850 lb)
Vehicle Weight
Tow Capacity Tongue weight 272 kg (600 lb)
Maximum trailer weight 1587 kg
(3,500 lb)
Ground Clearance 18 cm (7 inches) w/ no load
Wheel Base
118 cm (70 inches)
Wheel Tread (center Front: 117 cm (46 inches)
line to center line) Rear: 121 cm (47.7 inches)
Height 190.5 cm (75 inches) to top of ROPS

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
Before servicing or making adjustments to the
machine, stop the engine, set the parking brake,
and remove the key from the switch.

Checking the Engine-oil Level

Service Interval: Before each use or daily
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
sump for at least 10 minutes before checking. If the oil level is
at or below the Add mark on the dipstick, add oil to bring the
oil level to the Full mark. Do not overfill. If the oil level is
between the Full and Add marks, no additional oil is required.
The engine uses any Detergent diesel engine oil (API service
CH-4 or higher). Choose a viscosity according to the table
in Figure 10.
1. Position the machine on a level surface.
2. Remove the dipstick and wipe it with a clean rag. Insert
the dipstick into the tube and make sure it is seated
fully. Remove the dipstick and check the level of the oil.
3. If the oil level is low, remove the filler cap (Figure 11)
and add enough oil to raise the level to the Full mark
on the dipstick.
17
Figure 10