Indicator Lamp In The Charging Station - Husqvarna Automower 105 Operator's Manual

6.4 Indicator lamp in the charging station

The indicator lamp in the charging station must show a solid or flashing green light for a correct
installation. If not, follow the instructions in the troubleshooting guide below.
You can also find information on www.husqvarna.com. Speak to your Husqvarna
more information.
Light
Green solid light
Green flashing light
Blue flashing light
Yellow flashing light
Red flashing light
Red solid light
40 - Troubleshooting
Cause
Good signals.
The signals are good and
mode is activated.
The boundary loop is not connec-
ted to the charging station.
Break in the boundary loop.
The guide wire is not connected to
the charging station.
Break in the guide wire.
Interruption in the charging sta-
tion's antenna.
Fault in the circuit board or incor-
rect power supply in the charging
station. The fault should be recti-
fied by an authorized service tech-
nician.
Action
No action required.
ECO
No action required. For more informa-
ECO mode , Refer to ECO mode
tion on
on page 26 .
Check that the boundary wire connector
is fitted properly to the charging station.
To install the boundary wire on
Refer to
page 20 .
Find out where the break is. Replace
the damaged section of the boundary
wire with a new loop wire and splice us-
ing an original coupler. Refer to
breaks in the loop wire on page 42 .
Check that the guide wire connector is
properly connected to the charging sta-
To install the guide wire
tion. Refer to
on page 21 .
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Contact your local Husqvarna
sentative.
Contact your local Husqvarna
sentative.
®
customer service for
Find
®
repre-
®
repre-
1285 - 004 - 16.04.2020