Husqvarna Automower 105 Operator's Manual page 15

• The baseplate of the charging station must
not be bent.
Max 3 cm / 1.2"
• Put the charging station in the lower section
of the work area.
• Put the charging station in an area without
an irrigation system.
• Put the charging station in an area with
protection from the sun.
• If the charging station is installed on an
island, make sure to connect the guide wire
to the island. Refer to
page 17 .
3.4.2 To examine where to put the power
supply
WARNING: Do not cut or extend the
low-voltage cable. There is a risk of
electrical shock.
CAUTION: Make sure that the blades
on the product do not cut the low-
voltage cable.
1285 - 004 - 16.04.2020
To make an island on
WARNING: The power supply cable
and extension cable must be outside
the work area to avoid damage to the
cables.
CAUTION: Do not put the low-voltage
cable in a coil or below the charging
station plate. The coil causes
interference with the signal from the
charging station.
• Put the power supply in an area with a roof
and protection from the sun and rain.
• Put the power supply in an area with good
airflow.
• Use a residual-current device (RCD) when
you connect the power supply to the power
outlet.
Low-voltage cables of different lengths are
available as accessories.
3.4.3 To examine where to put the
boundary wire
CAUTION: There must be an obstacle
of minimum 15 cm / 6 in. in height
between the boundary wire and water
bodies, slopes, precipices or public
roads. This will prevent damage to the
product.
CAUTION: Do not let the product
operate on gravel.
CAUTION: Do not make sharp bends
when you install the boundary wire.
CAUTION: For careful operation
without noise, isolate all obstacles
such as trees, roots and stones.
Installation - 15