Husqvarna Automower 105 Operator's Manual page 38

Message Cause
No loop signal
The power supply or low-voltage cable
is not connected.
The power supply or low-voltage cable
is damaged or not connected.
The boundary wire is not connected to
the charging station.
The boundary is wire broken.
ECO mode is activated and the product
has attempted to start outside the
charging station.
The boundary wire is crossed on its
way to and from an island.
The pairing between the product and
the charging station is lost.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
The product is too far from the boun-
dary wire.
Mower tilted
The product is tilted more than the
maximum angle.
Connection NOT
Failed to change loop signal.
changed
38 - Troubleshooting
Action
If the LED status indicator on the
charging station is not lit, it shows that
there is no power. Examine the power
outlet connection and the residual-cur-
rent device. Make sure that the low-
voltage cable is connected to the
charging station.
Replace the power supply or low-volt-
age cable.
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Replace connectors if dam-
To install the boundary
aged. Refer to
wire on page 20 .
Do a check of the LED status indicator
on the charging station. If it shows
break in the boundary wire, replace the
damaged section with a new loop wire
and splice using an original coupler.
Put the product in the charging station,
start the product and close the hatch.
Check that the boundary wire is laid ac-
cording to instructions, e.g. in the right
direction around the island. Refer to
install the boundary wire on page 20 .
Put the product in the charging station
and generate a new loop signal. Refer
To create a New loop signal on page
to
26 .
Try to move the boundary wire and/or
make islands in the work area to in-
crease the signal strength.
Redo the installation of the boundary
wire so that all parts of the work area is
maximum 15 m / 50 ft. from the boun-
dary wire.
Move the product to a flat area.
New loop signal several
Try to create a
To create a New loop
times. Refer to
signal on page 26 . If the problem stays
speak to your authorized service tech-
nician.
1285 - 004 - 16.04.2020
To