Husqvarna Automower 105 Operator's Manual page 12

2.3.3 How to lift and move the product
WARNING: The product must be
switched off before lifting it. The
product is disabled when the Main
switch is in position
CAUTION: Do not lift the product when
it is parked in the charging station. It
can damage the charging station
and/or the product. Push STOP and
pull the product out of the charging
station before lifting it.
To safely move from or within the work area:
1. Push the STOP button to stop the product.
2. Set the main switch in position
3. Carry the product by the handle with the
blade disc away from the body.
2.3.4 Maintenance
WARNING: When the product is
turned upside down the main switch
must always be in the
12 - Safety
0 .
0 .
Inspect the product each week and replace any
damaged or worn parts. Refer to
page 31 .
2.3.5 In the event of a thunderstorm
To reduce the risk of damage to electrical
components in the product and the charging
station, we recommend that all connections to the
charging station are disconnected (power supply,
boundary wire and guide wire) if there is a risk of
a thunderstorm.
0 position.
The main switch should be set in the
position before all work on the chassis
of the product, such as cleaning or
replacing the blades.
CAUTION: Never use a high-pressure
washer or even running water to clean
the product. Never use solvents for
cleaning.
CAUTION: Use the plug to disconnect
the charging station before any
cleaning or maintenance of the
charging station or the loop wire.
Maintenance on
1285 - 004 - 16.04.2020
0