Troubleshooting; Introduction - Troubleshooting; Fault Messages - Husqvarna Automower 105 Operator's Manual

6.1 Introduction - troubleshooting

In this chapter, faults and symptoms are described and can guide you if the product does not operate
as expected. More suggestions for steps to take in the event of malfunction or symptoms can be found
on www.husqvarna.com.

6.2 Fault messages

The fault messages in the table below are shown in the display of the product. Speak to your
®
Husqvarna representative if the same message shows frequently.
Message Cause
Wheel motor
Grass or other object has wrapped
blocked, left/right
around the drive wheel.
Cutting system Grass or other object has wrapped
blocked
around the blade disc.
The blade disc lies in a pool of water.
The grass is too high.
Trapped The product is stuck in a small area be-
hind a number of obstacles.
Outside working
The boundary wire connections to the
area
charging station are crossed.
The boundary wire is too close to the
edge of the work area.
The work area slopes too much by the
boundary loop.
The boundary wire is laid in the wrong
direction around an island.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
The product finds it hard to distinguish
the signal from another product installa-
tion close by.

34 - Troubleshooting

6 Troubleshooting
Action
Check the drive wheel and remove the
grass or other object.
Check the blade disc and remove the
grass or other object.
Move the product and prevent the col-
lection of water in the work area.
Cut the grass before you install the
product. Make sure that the grass is
maximum 4 cm / 1.6 in.
Check if there are any obstacles which
make it hard for the product to move on
from this location. Remove the obsta-
cles or create an island around the ob-
stacles. Refer to
page 17 .
Check that the boundary wire is con-
nected correctly.
Check that the boundary wire has been
laid according to the instructions. Refer
to
20 .
Try moving the boundary wire.
Put the product in the charging station
and generate a new loop signal.
To make an island on
To install the boundary wire on page
1285 - 004 - 16.04.2020