To Charge The Battery; Adjust The Cutting Height - Husqvarna Automower 105 Operator's Manual

Timer setting Period 1 (A): 06:00 - 17:00
Timer setting Period 2 (C): 20:00 - 24:00
Active period (A): 06:00 - 17:00
Active period (C): 20:00 - 23:00
The product operates between 06:00 and 17:00.
It starts again at 20:00 but stops at 24:00 due to
standby mode until it starts again at 06:00.
Example: A specified work area of 500 m
Operation, A + C = max. hours
Charging/Standby, B + D = min. hours 10

4.7 To charge the battery

WARNING: Only charge the product
using a charging station which is
intended for it. Incorrect use may result
in electric shock, overheating or
leakage of corrosive liquid from the
battery.
In the event of leakage of electrolyte
flush with water and seek medical help
if it comes in contact with the eyes etc.
When the product is new or has been stored for a
long period, the battery can be empty and needs
to be charged before starting. In the
mode, the product automatically alternates
between mowing and charging.
1. Set the Main switch to position
2. Place the product in the charging station.
Slide the product in as far as possible to
30 - Operation
ensure proper contact between the product
and the charging station. Refer to contact
and charging plates in
page 4
3. The display shows a message that charging
is in progress.

4.8 Adjust the cutting height

The cutting height can be varied from MIN (2 cm /
0.8 in.) to MAX (5 cm / 2 in.).
Note: During the first week after a new
installation, the cutting height must be set to MAX
to avoid damaging the loop wire. After this, the
cutting height can be lowered step by step every
second week until the desired cutting height has
been reached.
4.8.1 To adjust the cutting height
1. Press the STOP button to stop the product
and open the hatch.
2. Turn the height adjustment knob to the
required position. The selected position is
indicated by the orange column on the
2
height adjustment indicator.
14
•
•
3. Close the hatch.
Main area
1 .
Product overview on
Turn counterclockwise to increase the
cutting height.
Turn clockwise to lower the cutting
height.
1 2 3 4 5
1285 - 004 - 16.04.2020