Information Messages - Husqvarna Automower 105 Operator's Manual

6.3 Information messages

The information messages in the table below are shown in the display of the product. Speak to your
®
Husqvarna representative if the same message shows frequently.
Message Cause
Low battery
The product cannot find the charging
station.
The battery is spent.
The charging station's antenna is de-
fective.
The charging plates on the product or
contact plates on the charging station
are corroded.
Settings restored
Confirmation that
tings has been carried out.
Guide not found
The guide wire is not connected to the
charging station.
Break in the guide wire.
The guide wire is not connected to the
boundary loop.
Guide calibration
The product has failed to calibrate the
failed guide wire.
Guide calibration
The product has succeeded to calibrate
done
the guide wire.
Connection
New loop signal successfully changed.
changed
1285 - 004 - 16.04.2020
Action
Change the position of the guide wire.
Refer to
page 21 .
Replace the battery. Refer to
on page 32 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 40 .
Clean the charging and contact plates
using a fine grade emery cloth. If the
problem stays speak to your approved
servicing dealer.
Reset all user set-
No action.
Check that the guide wire connector is
tightly connected to the charging sta-
tion. Refer to
on page 21 .
Find out where the break is and rectify
it.
Check that the guide wire is connected
correctly to the boundary loop. Refer to
To install the boundary wire on page
20 .
Check that the guide wire is installed
according to the instructions. Refer to
To install the guide wire on page 21 .
No action.
No action.
To install the guide wire on
Battery
To install the guide wire
Troubleshooting - 39