Husqvarna Automower 105 Operator's Manual page 20

WARNING: Risk of Electric Shock.
Install only to an residual-current
device (RCD) when connecting the
power supply to the power outlet.
Applicable to USA/Canada. If power
supply is installed outdoors: Risk of
Electric Shock. Install only to a
covered Class A GFCI receptacle
(RCD) that has an enclosure that is
weatherproof with the attachment plug
cap inserted or removed.
CAUTION: Do not make new holes in
the charging station plate.
CAUTION: Do not put your feet on the
baseplate of the charging station.
WARNING: The power supply cable
and extension cable must be outside
the work area to avoid damage to the
cables.
When connecting the power supply, only use a
power outlet that is connected to an residual-
current device (RCD).
1. Read and understand the instructions about
where to put the charging station. Refer to
To examine where to put the charging
station on page 14 .
2. Put the charging station in the selected area.
Note: Do not attach the charging station with
the screws to the ground until the guide wire
To install the guide wire
is installed. Refer to
on page 21 .
3. Connect the low-voltage cable to the
charging station.
4. Put the power supply at a minimum height of
30 cm / 12 in.
20 - Installation
min 30 cm / 12"
5. Connect the power supply cable to a
100-240V power outlet.
Note: When the charging station is
connected, it is possible to charge the
product. Place the product in the charging
station while the boundary and guide wires
are being laid. Switch on the product. Refer
Main switch on page 28 . Do not continue
to
with any product settings before the
installation is complete.
6. Put the low-voltage cable in the ground with
stakes or bury the cable. Refer to
wire into position with stakes on page 22 or
To bury the boundary wire or the guide wire
on page 22 .
7. Connect the wires to the charging station
after the installation of boundary wire and
guide wire is complete. Refer to
the boundary wire on page 20 and To
install the guide wire on page 21 .
8. Attach the charging station to the ground
with the supplied screws after the guide wire
To install the guide wire
is installed. Refer to
on page 21 .
3.5.3 To install the boundary wire
CAUTION: Do not put remaining wire
in a coil. The coil causes interference
with the product.
1. Put the boundary wire around all of the work
area. Start and complete the installation
behind the charging station.
2. Open the connector and put the boundary
wire in the connector.
To put the
To install
1285 - 004 - 16.04.2020