Husqvarna Automower 105 Operator's Manual page 16

The boundary wire should be put as a loop
around the work area. Sensors in the product
senses when the product approaches the
boundary wire, and the product selects another
direction. All parts of the work area must be
maximum 15 m / 50 ft. from the boundary wire.
To make the connection easier between the
guide wire and the boundary wire, it is
recommended to make an eyelet where the guide
wire will be connected. Make the eyelet with
approximately 20 cm / 8 in. of the boundary wire.
Note: Make a blueprint of the work area before
you install the boundary wire and guide wire.
E
C
A
• Put the boundary wire around all of the work
area (A). Adapt the distance between the
boundary wire and obstacles.
16 - Installation
•
•
•
D
F
•
B
•
Put the boundary wire 25 cm / 10 in. (B)
from an obstacle that is more than 5 cm / 2
in. high.
25 cm /10
Put the boundary wire 20 cm / 8 in. (C) from
an obstacle that is 1-5 cm / 0.4-2 in. high.
"
20 cm / 8
1-5 cm / 0.4 - 2
Put the boundary wire 5 cm / 2 in. (D) from
an obstacle that is less than 1 cm / 0.4 in.
high.
"
5 cm / 2
max 1 cm / 0.4
If you have a paving stone path that is in
level with the lawn, put the boundary wire
below the paving stone.
Note: If the paving stone is minimum 30 cm /
12 in. wide, use the factory setting for the
Drive Past Wire function to cut all the grass
adjacent to the paving stone. Refer to
the Drive Past Wire function on page 25 .
If you make an island, put the boundary wire
that runs to and from the island near
together (E). Put the wires in the same
1285 - 004 - 16.04.2020
"
> 5 cm / 2
"
"
"
To set