Installing Left Driveline - MacDon R216 Installation Instructions Manual

3.7 Installing Left Driveline

WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
1. Apply anti-seize compound on splined shaft (A).
2. Insert driveline (B) at an angle and guide it past hub
drive (C) and drum (D).
3. Insert splined spindle end (A) into the splined bore of
driveline (B).
4. Place a bead of high-strength threadlocker (Loctite
equivalent) around the threads of four M12 hex flange
head bolts (A). Use the bolts to secure driveline
assembly (B) to hub drive (C). Torque bolts to 100 Nm
(74 lbf·ft).
5. Position driveline shield (B) as shown. Apply a bead of
medium-strength threadlocker (Loctite
around the threads of two M10 hex flange head bolts (A).
Use bolts (A) to secure driveline shield (B) in place.
215339
INSTALLATION INSTRUCTIONS
Figure 3.30: Drum and Tube Shield – Cutaway View
®
262 or
Figure 3.31: Driveline
®
243 or equivalent)
Figure 3.32: Driveline Shield
20
D
A
B
A
C
B
A
C
A
B
Revision A