Chapter 3: Installation Instructions; Opening Cutterbar Doors - North America - MacDon R1 Series Installation Instructions Manual

Chapter 3: Installation Instructions

To install the cutterbar kits, follow these steps and procedures in the order given.
NOTE:
Some steps and procedures only apply to some machines. These are clearly labelled.
3.1 Opening Cutterbar Doors – North America
If the machine was sold outside of North America, it will have export latches. Refer to
Latches, page 8.
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
1. Pull-types only: If both doors need to be opened, center the pull-type beneath the hitch.
2. Shut down the engine, and remove the key from the ignition.
3. Lift up on doors (A) at the front of the machine.
214497
3.2 Opening Cutterbar Doors – Export
A
Figure 3.1: Cutterbar Doors and Curtains – Pull-Type
A
Figure 3.2: Cutterbar Doors and Curtains –
Windrower Header
7
A
Revision D