Remote control (Fig. 1, page 3)
The CARiN Navigation System is controlled by one of the infrared remote
controls shown in figure 1, depending on the version.
Press the release keys at both sides of the holder to remove the remote
Before driving off, slide the remote control back into the holder until it
clicks into position.
The keys on the remote control have the following functions:
Plan an alternative route.
Repeat current acoustical guidance advice.
Cursor key upwards; select options.
Cursor key left; select options.
Cursor key right; select options.
Cursor key downwards; select options.
ENTER/O.K. Enter or O.K.* key; confirm a selection.
Decrease voice volume of guidance advice.
Increase voice volume of guidance advice.
Show Main Menu.
Enter/exit the route map or car position map
(in all menus where a map option is available)
Only highlighted options can be selected with the cursor keys.
If you use your remote control in it's holder, the internal batteries are not
When the batteries are exhausted the ( icon lights up in the status line of the
Slide the remote control into its holder to resume normal operation.
Replace the batteries.
The keyboard of the remote control is illuminated when you press one of the
keys. The illumination is switched off automatically after a while. When inserted
in the holder the keyboard is illuminated permanently as long as the ignition is
Downloaded from www.nmis.nl
* only certain versions