1990-94 Lumina; 1994-96 Lumina Apv; Silhouette; Trans Sport - Scosche GM1503 Nstallation Instructions

1990-94 Chevrolet Lumina
Radio Removal:
1. Remove the two screws from the lower steering column trim piece (below the
column). Pull the panel down to access the bottom portion of the dash trim.
2. Pull outward along the top and bottom portion of the trim panel. Release each vent's individual spring clip.
3. Extract the four screws from the radio bracket.
4. Pull the unit out of the cavity. Disconnect the connectors and remove the unit.
NOTES:  Due to its rear support, you might need to use slight force to pull the radio free.
 The factory antenna uses a micro-size jack. We recommend Radio Shack's GM antenna adaptor
(Cat. number 12-1336).
LEFT
LADO IZQUIERDA
"A1" BRACKE USE HOLE #2
"A1" SOPORTE USA
ABERTURA NO. 2
2
1
"C2" BRACKET USE HOLE #1
"C2" SOPORTE USA ABERTURA NO. 1
FRENTE DE ESTUCHE
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1994-96 Chevrolet Lumina APV
1994-96 Oldsmobile Silhouette
1994-96 Pontiac Trans Sport
Radio Removal:
1. Open the glove box door and remove the two Phillips-head screws at the right edge of the console.
9
2. Extract one / inch hex screw from the interior fan motor cover.
32
3. On the driver's side, extract the three 9 / inch hex head screws just below the steering column, one above
32
the hood release, one above the diagnostics plug, and one at the left side of the center console.
4. With the three screws extracted from the under dash cover there is one spring clip holding it, unsnap and
remove the cover.
5. Release the four spring clips holding the panel along the bottom of the instrument cluster. Remove the
panel.
6. Extract the four 10mm bolts holding the metal steering column access panel, remove the bolts.
7. Extract the two Phillips-head screws along the left edge of the console which become accessible from
"step 6".
8. Slide the center console straight outward, unplug all the electrical connectors and remove.
9. Extract the two 10mm bolts underneath the front edge of the radio.
10. Extract the two T-15 Torx
bolts above the front edge
of the radio.
11. Slide the radio out of the
dash, unplug all the
connectors and the
antenna. Remove the
radio.
BOTTOM
FONDO
USE THE SUPPLIED CARRIAGE BOLTS & NUTS TO MOUNT THE KIT PANEL TO THE SUB-DASH.
Usa los pernos de portey tuercos proveidos para montar la tablera estuche al tablero-sub.
RIGHT
LADO DERECHO
"B1" BRACKET USE HOLE #3
"B1" SOPORTE USA
ABERTURA NO. 3
3
1
"B2" BRACKET USE HOLE #1
FRONT OF KIT
"B2" SOPORTE USA ABERTURA NO. 1
FLANGE NUT
TUERCO REBORDE
TOP
TOPE
CARRIAGE BOLT
PERNO DE PORTE
20
Read pages
3-7 for kit
assembly.
Read pages
3-7 for kit
assembly.