Cavalier Rs, Z-24; 1982-90 Celebrity - Scosche GM1503 Nstallation Instructions

1
1985 / -90 Chevrolet Cavalier RS, Z24
2
Radio Removal: (All Z24 Models, RS Models through 1988)
1. Carefully pull outward on the console/radio trim panel. Spring clips are located
along the top, middle and bottom of the panel.
2. Pull the panel away from the dash, disconnect the ashtray light and remove the panel.
3. Loosen two nuts along the bottom of the radio chassis.
4. Pull the radio out, disconnect the connectors and remove the radio.
Radio Removal: (1989-90 RS Models)
1. Remove the two fasteners under the air vents, along the top front of the radio/climate control trim
housing, and remove the trim housing.
2. Remove the two fasteners from the backside of the trim housing and remove the housing.
3. Loosen the two nuts securing the radio, slide the unit out, disconnect the leads and remove the unit.
FLANGE NUT
TUERCO REBORDE
BOTTOM
FONDO
USE THE SUPPLIED CARRIAGE BOLTS & NUTS TO MOUNT THE FACTORY RADIO BRACKET ON THE TOP OF THE KIT.
Usa los pernos de porte y tuercos para montar el soporte de radio de la fabrica arriba del estuche.
1982-90 Chevrolet Celebrity
Radio Removal:
1. Open the glove box and slide the box towards the rear of the car.
2. Remove the five 1/2 inch nuts from the backside of the dash trim panel (directly above the glove box).
3. Release the locking clip from the headlight knob and remove the knob. Unscrew the plastic nut from
behind the headlight knob and remove the nut.
4. Remove the ashtray and extract the three screws from the upper rear edge of the lower dash trim piece.
5. Unhook the cigarette lighter wiring. Unscrew the two-piece cigarette lighter (hold the rear piece behind the
dash while unscrewing the front piece from the front side of the dash).
6. Remove the dash trim panel.
7. Remove the two screws from the right and one screw from the left of the radio, pull the radio out of the
cavity. Disconnect the antenna, speaker and all the electrical connections, then remove the radio.
LEFT
LADO IZQUIERDA
6
FRONT OF KIT
FRENTE DE ESTUCHE
"A2" BRACKET USE HOLE #3
"A2" SOPORTE USA ABERTURA NO. 3
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
Read pages
3-7 for kit
assembly.
TOP
TOPE
CARRIAGE BOLT
PERNO DE PORTE
Read pages
3-7 for kit
assembly.
"D1" BRACKET
USE HOLE #4
"D1" SOPORTE
RIGHT
USA ABERTURA NO. 4
LADO DERECHO
4
4
"D2" BRACKET USE
HOLE #4
"D2" SOPORTE USA
ABERTURA NO. 4
18