1991-96 Beretta; 1989-91 Blazer, Full Size; 1997-02 Camaro; 1991-96 Corsica - Scosche GM1503 Nstallation Instructions

1991-96 Chevrolet Beretta
1991-96 Chevrolet Corsica
Radio Removal:
1. Remove the radio trim bezel by prying outward with
a panel removal tool/screwdriver releasing the snap
clips securing it to the dash.
2. Extract two screws securing the radio to the dash.
Pull the radio out of the cavity, unplug all
connectors and remove the radio.
USE THE SUPPLIED CARRIAGE BOLTS & NUTS TO MOUNT THE FACTORY RADIO BRACKET ON THE BOTTOM OF THE KIT.
Usa los pernos de porte y tuercos para montar el soporte de radio de la fabrica en el fondo del estuche.
1989-91 Chevrolet Blazer/Jimmy-Full Size
1989-91 Chevrolet Suburban
1989-91 GMC Crew-Cab Dually Pickup
Radio Removal:
1. Remove the eight screws securing the instrument/radio trim panel.
2. Extract the four screws from the steering column bottom trim piece, two on each side of the column.
3. Place the gear selector in low (one) gear to provide additional clearance, then remove the instrument/
radio trim panel from the
dash.
CARRIAGE BOLT
PERNO DE PORTE
4. Extract the two bolts
securing the face of the
radio; then, from below
the dash, remove the rear
support bolt from the
bottom of the dash sheet
metal.
5. Pull the radio out of the
FLANGE NUT
dash cavity, disconnect TUERCO REBORDE
the radio harnesses and
antenna, then remove the
radio.
USE THE SUPPLIED CARRIAGE BOLTS AND NUTS TO MOUNT THE FACTORY RADIO BRACKETS TO THE KIT PANEL.
Usa los pernos de porte y tuercos para montar los soportes de radio fabricada al panel del estuche.
1997-02 Chevrolet Camaro
Radio Removal:
1. Carefully pry out on the
dash trim bezel to
"A1" BRACKET
release the fastening
USE HOLE #2
"A1" SOPORTE USA
clips, unplug all switches
ABERTURA NO. 2
and remove the bezel.
2. Extract two screws
securing the radio,
unplug and remove.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
CARRIAGE BOLT
PERNO DE PORTE
BOTTOM
FONDO
FLANGE NUT
TUERCO REBORDE
RIGHT
DERECHO
1
1
BOTTOM
FONDO
"B1" BRACKET
USE HOLE #2
RIGHT SIDE
LEFT SIDE
"B1" SOPORTE USA
LADO DERECHO
LADO IZQUIERDA
ABERTURA NO. 2
FRONT OF KIT
FRENTE DE ESTUCHE
15
Read pages
3-7 for kit
assembly.
Read pages
3-7 for kit
assembly.
FBA RIGHT
BRACKET
SOPORTE
DERECHO FBA
Read pages
3-7 for kit
assembly.