1991-94 Roadmaster; 1982-89 Skyhawk; Caprice/Caprice Classic; Firenza - Scosche GM1503 Nstallation Instructions

1991-94 Buick Roadmaster
1991-93 Chevrolet Caprice/
Caprice Classic
Radio Removal:
1. Remove the two screws from along the bottom of the dash which secure the service panel (driver's side).
Pull down on the panel to release the four clips and remove the panel.
2. Carefully pry off the trim piece from above the glove box. Remove the screw located behind the trim
location.
3. Remove the three screws from the dash bezel (underside of dash pad).
4. Remove one screw from the lower left inside corner of the glove box.
5. Remove one screw from the parking brake release cavity.
6. Work around the perimeter of the dash bezel and release all the spring clips. Tilt the steering wheel down,
place the shifter into low and remove the dash bezel.
7. Remove the three screws securing the radio, disconnect the connectors and remove the radio.
"C2" BRACKET
USE HOLE #4
"C2" SOPORTE
USA ABERTURA
NO. 4
"B2" BRACKET USE HOLE #4
"B2" SOPORTE USA ABERTURA NO. 4
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1982-89 Buick Skyhawk
1982-88 Oldsmobile Firenza
Radio Removal:
1. Disconnect the support strap from the glove box door.
2. Remove the four screws securing the glove box liner.
3. Pull the glove box liner outward and remove it.
4. Remove the two screws from below the lighter/heater controls.
5. Remove the three screws securing the lower dash panel (each side of the steering column).
6. Pull the panel down to expose the screw under the panel, and to the left of the heater control. Unsnap the
panel assembly and remove it.
7. Remove the four screws securing the radio to the dash; pull the radio out of the dash cavity.
8. Disconnect the antenna and all the electrical connections, then remove the radio.
"C2" BRACKET USE
HOLE #5
"C2" SOPORTE USA
ABERTURA NO. 5
BOTTOM
FONDO
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
Read pages
3-7 for kit
assembly.
BOTTOM
FONDO
CUT OFF TABS
(TWO BRACKETS)
CORTA LOS LENGUETES
(DOS SOPORTES)
Read pages
3-7 for kit
assembly.
"C1" BRACKET USE HOLE #5
"C1" SOPORTE USA
ABERTURA NO. 5
"B1" BRACKET USE
HOLE #5
"B1" SOPORTE USA
TOP
ABERTURA NO. 5
TOPE
"B2" BRACKET USE HOLE #5
"B2" SOPORTE USA ABERTURA NO. 5
11