1992-95 Deville; 1986-91 Eldorado; 1985-92 Fleetwood; 1986-91 Seville - Scosche GM1503 Nstallation Instructions

1992-95 Cadillac DeVille
Radio Removal:
NOTE: The following
FLANGE NUT
information is for the non-Bose
TUERCO REBORDE
stereo equipped vehicle.
1. Carefully pull out on the
radio perimeter trim bezel.
2. Push the two tabs in on the
sides of the factory stereo.
One on the upper left side
and one on the lower right
side.
3. Slide the radio out, unplug
and remove the radio.
FBA LEFT
BRACKET
SOPORTE
IZQUIERDA FBA
CARRIAGE BOLT
PERNO DE PORTE
USE THE SUPPLIED CARRIAGE BOLT AND NUTS TO MOUNT THE FACTORY RADIO BRACKET TO THE FBA BRACKET.
Usa los pernos de porte y tuercos para montar el soporte de radio de fabrica al soporte FBA.
1985-91 Cadillac DeVille
1985-92 Cadillac Fleetwood
Radio Removal:
1. Remove (2) Phillips head sheet metal
screws from top edge of the radio
trim panel. Remove the trim
panel.
2. Remove (2) 7mm hex head
bolts from the top radio
mounting bracket.
3. Open ashtray and remove (1)
7mm hex head screw (farthest
towards rear of car on driver's
side).
4. Slide the radio out of cavity,
FRONT OF KIT
disconnect all wiring, and FRENTE DE ESTUCHE
remove radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1986-91 Cadillac Eldorado
1986-91 Cadillac Seville
Radio Removal:
1. Gently pry on the edges of the vent trim piece
located above the radio. Release the snaps
and remove the trim piece.
2. Remove the three screws from above the
radio.
3. Extract the three screws from the dash panel
trim piece above the instrument cluster.
4. Gently pry out the driver's side air vent in the
dash trim to access the single screw which
secures the left side of the trim panel. Remove
the screw and the trim panel.
5. Loosen the two bolts which secure the radio to
the dash. Slide the radio out of the cavity.
Disconnect the antenna, speakers, all the
electrical connections and remove the radio.
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
Read pages
3-7 for kit
assembly.
LEFT
RIGHT
LADO
LADO DERECHO
IZQUIERDA
1 1
FBA RIGHT
BRACKET
1
1 SOPORTE
DERECHA FBA
FRONT OF KIT
FRENTE DE ESTUCHE
Read pages
3-7 for kit
assembly.
"D1" BRACKET USE HOLE #2
"D1" SOPORTE USA ABERTURA NO. 2
TOP
TOPE
"C1" BRACKET
USE HOLE #2
"C1" SOPORTE
USA ABERTURA
NO. 2
Read pages
3-7 for kit
assembly.
"B2" BRACKET USE HOLE #2
"B2" SOPORTE USA ABERTURA NO. 2
TOP
TOPE
CUT OFF TAB
CORTA EL LENGUETE
FRONT OF KIT
FRENTE DE ESTUCHE
13