1984-85 Eldorado; 1984-85 Seville; Chevrolet 1990-95 Astro; 1985-89 Astro - Scosche GM1503 Nstallation Instructions

1984-85 Cadillac Eldorado
1984-85 Cadillac Seville
Radio Removal:
1. Remove the two screws from the top of the radio trim panel and remove the trim panel.
2. Remove the two screws
LEFT SIDE
securing the radio bracket
LADO IZQUIERDA
to the dash, then pull the
radio out of the cavity.
3. Disconnect the antenna,
speakers and all the
electrical
connections,
then remove
the radio.
3
"A2" BRACKETUSE HOLE #1
"A2" SOPORTE
USA ABERTURA NO. 1
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1990-95 Chevrolet Astro
1990-95 GMC Safari
Radio Removal:
1. Remove two screws from the underside of the center dash trim piece.
2. Carefully release the spring clips securing the center panel trim piece (trim snaps off).
3. Pull the trim away
"C1" BRACKET USE HOLE #4
from the dash, "C1" SOPORTE USA
ABERTURA NO. 4
disconnect the various
electrical connections,
and remove the panel.
4. Extract the four
screws securing the
TRIM
radio to the dash, two BRACKET
CORTA EL
screws at each side.
SOPORTE
Pull the radio out of
the cavity, and
disconnect the antenna
and electrical
"A2" BRACKET USE HOLE #3
harnesses. Remove
"A2" SOPORTE USA
the radio.
ABERTURA NO. 3
USE THE SHADED BRACKETS & THE INDICATED HOLE LOCATIONS. CUT OFF THE REMAINING BRACKETS AND DISCARD.
Usa los soportes asombrados y las localizaciónes de aberturas indicadas. Corta los soportes que sobran y desechalas.
1985-89 Chevrolet Astro
1985-89 GMC Safari
Radio Removal:
1. Remove three screws from the top edge of the radio trim panel.
2. Remove two 10mm bolts from the lower edge of the trim
panel (inside glove box).
3. Pull the console trim towards the rear of the vehicle and
remove two 7mm bolts from behind the trim. Remove the
radio trim panel.
4. Remove two screws from the bottom of the radio retainer
bracket.
5. Carefully pull the radio out of the cavity. Disconnect the
antenna, speaker and all electrical connections, the
remove the radio.
USE THE "E" BRACKETS ON THE BOTTOM LEFT AND BOTTOM RIGHT SIDE OF THE KIT.
Usa los soportes "E" abajo en los lados izquierda y derecha del estuche.
Read pages
3-7 for kit
assembly.
RIGHT SIDE
LADO DERECHO
3
FRONT OF KIT
FRENTE DE ESTUCHE "D2" BRACKETUSE HOLE #1
"D2" SOPORTE
USA ABERTURA NO. 1
Read pages
3-7 for kit
assembly.
LEFT SIDE RIGHT SIDE
"D1" BRACKET
LADO IZQUIERDA LADO DERECHO
USE HOLE #2
8
8 7 "D1" SOPORTE
7
6
5
FRONT OF KIT
"B2" BRACKET USE HOLE #1
FRENTE DE ESTUCHE
"B2" SOPORTE USA
ABERTURA NO. 1
Read pages
3-7 for kit
assembly.
E
14
USA
ABERTURA
NO. 2
E