Scosche GM1482 Quick Start Manual

IN-DASH INSTALLATION KIT FOR
1988-94 GENERAL MOTORS
1500 SERIES FULL SIZE TRUCKS
SNAP
SHAFT
TABS
Vehicle Applications:
CHEVROLET / GMC
1992-94 BLAZER - FULL SIZE
1992-94 CREW CAB DOOLEY PICKUP
1988-94 PICKUP - FULL SIZE
1992-94 SUBURBAN
1992-94 YUKON
For Factory Wiring Codes go to:
CAUTION:
Disconnect your vehicle's negative battery terminal before the installation to help prevent electrical
Damage. We recommend the use of a volt/ohm meter over a test light to check wiring. A test light or
grounded wire probe can cause damage to the vehicle's computer and/or diagnostic systems. Avoid all
factory air bag wiring - air bags can accidentally deploy causing serious injury or death.
NOTES:
See your vehicle's instructions for any special tools your installation might require. Read all instructions
accompanying your car stereo/cassette player for proper wiring and mounting instructions.
This instruction booklet is based on carefully documented data and research of automobile dash disassembly, wire harness/
codes and information pertaining to installation of this kit (GM1482) in 1988-94 GM Vehicles. Scosche Industries, Inc. can not
be held responsible for discrepancies/inconsistencies that may occur due to the automobile manufacturing changes or
options, or damage that may occur in the automobile during the installation of components while using this booklet.
If you have any further questions, call
© 2003 SCOSCHE INDUSTRIES, INC.
SHAFT
RADIO
FACTORY WIRE CODES
www.scosche-cars.com
INTRODUCTION/PRELIMINARY INTRODUCTION/PRELIMINARY INTRODUCTION/PRELIMINARY
INTRODUCTION/PRELIMINARY INTRODUCTION/PRELIMINARY
LIABILITY DISCLAIMER
MOUNTING
PANEL
ILLUSTRATION A
NOTE: Scosche MDA-1 antenna adapter
and GM02 factory connector (sold
separately) are needed to
complete the installation.
TECH HELP 1-800-621-3695x3
SI 6/03 - GM1482 (3000156)
GM1482