Led Display When The Pc7501 Starts Up Normally - Renesas M30290T-EPB User Manual

4.1.4 LED Display When the PC7501 Starts Up Normally

Figure 4.1 shows upper panel LED lighting status when the emulator started up properly. Check it when starting up the
emulator system.
Figure 4.1 LED display of the PC7501 when the power turned on
Note on the Target Status POWER LED:
If your MCU has two or more Vcc terminals, the LED does not light unless power is supplied to all the
terminals.
Note on the Target Status CLOCK LED:
If the LED is not turned on, check the following.
(1) After powering on the PC7501 (before starting up the emulator debugger):
Make sure that the oscillator circuit board is properly installed in the PC7501 and it is oscillating
normally.
(2) After the emulator debugger is started up (after the Init dialog box settings are completed):
Make sure that the oscillator selected in the Init dialog box is oscillating normally.
・If this LED does not light, check the voltage of the user system.
・Check that power is supplied to all the power terminals.
・When the user system is not connected, this LED does not light.
: ON
P O W E R P O W E R
: OFF
S A F E C LO C K
: Flashing
E R R O R R E S E T
R U N
W A R N IN G
SYSTEM TARGET
STATUS STATUS
IMPORTANT
( 39 / 58 )
Chapter 4. Usage