Connecting To An 80-Pin 0.5-Mm-Pitch Foot Pattern - Renesas M30290T-EPB User Manual

3.4.4 Connecting to an 80-pin 0.5-mm-pitch Foot Pattern

Here following is a procedure of connecting to an 80-pin 0.5-mm-pitch foot pattern on the user system using the
M30290T-80FPD (included with the M30290T-EPB-HP). For details on the M30290T-80FPD, refer to its user's
manual.
(1) Mount the NQPACK080SD-ND included with the M30290T-80FPD to the user system.
(2) Attach the YQPACK080SD included with the M30290T-80FPD to the NQPACK080SD-ND and secure it with the
YQ-GUIDE's.
(3) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M30290T-EPB.
(4) Attach the M30290T-80FPD to the YQPACK080SD.
Figure 3.13 Connecting to an 80-pin 0.5-mm-pitch foot pattern
Notes on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the
emulator and targets system.
The connectors of the M30290T-EPB and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
(1) Debugging
(3)
M30290T-PTCB
YQ-GUIDE (x4) *
YQPACK080SD *
NQPACK080SD-ND *
: No. 1 pin
* : These products are included with the M30290T-80FPD package.
M3T-FLX160-EPB
M30290T-EPB
M30290T-80FPD
(2) On-board evaluation
(4)
HQPACK080SD
(2)
(1)
80-pin 0.5-mm-pitch
(80P6Q-A) foot pattern
CAUTION
( 35 / 58 )
Chapter 3. Setup
(not included)
MCU with on-chip
flash memory etc.