Acpi Configuration - DFI PR610-C621 User Manual

Advanced
X

ACPI Configuration

InsydeH2O Setup Utility
Advanced
ACPI Configuration
Wake On LAN <Disabled>
After G3 <Always On>
Wake On RTC <Enabled>
Wake up time [00:00:00]
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
Wake On LAN
Enable or Disable this field to allow LAN signal to power up the system.
After G3
This field is to specify what state the system should be in when power is re-applied after a
power failure.
Always On The system automatically powers on after power failure.
Always Off The system remains power off after power failure. Power-on signal input is re-
quired to power up the system.
Wake On RTC
When Enabled, the system will automatically wake up from S4/S5 state at a designated time
every day via the Real-time clock (RTC) battery.
[Wake up time]
Configure the time of day the system will wake on RTC — [HH:MM:SS]. This field will only ap-
pear when "Wake On RTC" is enabled.
User's Manual | PR610-C621
Rev. 5.0
Determines the action tak-
en when the system power
i s o f f a n d a P C I P o w e r
Management Enable wake
up event occurs.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
InsydeH2O Setup Utility
Advanced
ACPI Configuration
Wake On LAN <Disabled>
After G3 <Always On>
BGRT Logo <Enabled>
Wake On RTC <Enabled>
Wake up time [00:00:00]
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
BGRT Logo
This field is used to enable or disable to support display logo with ACPI BGRT table. This field
is only available when Quiet Boot is enabled.
Note:
To enable "Quiet Boot", please refer to the Boot menu section in this chapter for
more information.
Chapter 3
BIOS SETTINGS
Rev. 5.0
Support display logo with
ACPI BGRT table.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
27