Com (Serial) Ports; Rj45 Lan Ports - DFI PR610-C621 User Manual

Rear I/O Ports
X

COM (Serial) ports

COM 2 (DB9)
COM 1 (DB9)
„ BMC COM port
9 1
2
The serial ports are asynchronous communi-
cation ports with 16C550A-compatible UARTs
that can be used with modems, serial print-
ers, remote display terminals, and other serial
devices.
The three COM ports support RS232 — two
stacked DB9 connectors at the rear side and
one internal pin-header connector for monitor-
ing the BMC.
BIOS Setting
Configure the display devices in the "Ad-
vanced" menu ("Console Redirection" and "SIO
NCT6112D" submenus) of the BIOS. Refer to
the chapter 3 for more information.
Note:
The BMC COM port is used to monitor the IPMI functions and the BMC on the
SEM2500/SEM2510 card.
User's Manual | PR610-C621
„ COM Port Pin Assignment
RS232
Pin DB9 Pin header
1 DCD DCD
2 SIN DSR
3 SOUT RX
4 DTR RTS
5 GND TX
6 DSR CTS
7 RTS DTR
8 CTS RI
9 RIN GND
Rear I/O Ports
X

RJ45 LAN Ports

LAN 1
MGMT Port (optional)
The LAN ports allow the system board to connect to a local area network (LAN) by means of a
network hub. The MGMT port is only available when SEM2500 is supported.
BIOS Setting
Configure the onboard LAN ports in the "Advanced > PCI Express Configuration" submenu of
the BIOS; for the MGMT Port, go to "H2O IPMI Configuration > BMC configuration" submenu.
Refer to chapter 3 for more information.
Driver Installation
Install the LAN drivers. Refer to the chapter 4 for more information.
Features
• 2 x Intel I210AT PCIe (10/100/1000Mbps)
®
• 1 x RTL8211F only with SEM2500
Chapter 2
HARDWARE INSTALLATION
LAN 2
16