Pci Express Configuration; Debug Configuration - DFI PR610-C621 User Manual

Advanced
X

PCI Express Configuration

InsydeH2O Setup Utility
Advanced
PCI Express Configuration
►CPU PCIE Configuration
►PCH PCIE Configuration
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
►CPU PCIE Configuration
Press Enter to enter the sub-menu and configure the PCIE ports — PCIE1, PCIE2, PCIE3,
PCIE4.
►PCH PCIE Configuration
Press Enter to enter the sub-menu and configure the PCIE devices — LAN1, LAN2, and M.2
slot.
►PCIE1/PCIE2/PCIE3/PCIE4/LAN1/LAN2/M.2 slot
Port Enable
Enable or disable the PCI Express Root Port.
PCIe Speed
Select PCIe Speed of the current port — AUTO, Gen1 (2.5 GT/s), Gen2 (5 GT/s), or Gen3 (8
GT/s). Gen 3 is only available for the PCIE1 port. This field may not appear when the speed of
the port is not configurable.
Hot Plug
Enable or disable hot plug function of the port. This field may not appear when the port does
not support hot plug.
User's Manual | PR610-C621
Rev. 5.0
Enable/Disable SATA
Device.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
Advanced
X

Debug Configuration

This section configures Debug setting.
InsydeH2O Setup Utility
Advanced
Debug Configuration
Dynamic EFI DEBUG <On>
EFI debug print level [0x8000004F]
EFI debug serial port [0x3F8]
EFI debug baud rate [115200]
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
Dynamic EFI DEBUG
This field is used to turn on or off the function to output debug message from COM port. When
this field is set to "On", the following EFI debug configurations will be displayed.
EFI debug print level
Default value is 0x8000004F.
EFI debug serial port
Default value is 0x3F8.
EFI debug baud rate
Default value is 115200.
Chapter 3
BIOS SETTINGS
Rev. 5.0
Enable it to output debug mes-
sage from COM port.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
31