Sio Ast2500/Ast2510; H2O Ipmi Configuration - DFI PR610-C621 User Manual

Advanced
X

SIO AST2500/AST2510

View the super I/O settings in this submenu.
InsydeH2O Setup Utility
Advanced
BMC UART <Enable>
Base I/O Address <2F8>
Interrupt <IRQ6>
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
BMC UART
Enables or disables the serial ports (COM). The following bracketed fields will only appear
when the port is enabled.
Note:
SIO AST2500/AST2510 is only present when the board supports the IPMI func-
tions and equipped with SEM2500/SEM2510.
User's Manual | PR610-C621
Rev. 5.0
Configure Serial port using op-
tions: [Disable] No Configura-
tion [Enable] User Configuration
[Auto] EFI/OS chooses configu-
ration
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
Advanced
X

H2O IPMI Configuration

InsydeH2O Setup Utility
Advanced
IPMI Support <Enable>
BMC Warm Up Time [60]
Syetem Interface Type KCS
IPMI Base Address for OS CA2/CA3
IPMI Base Address for POST CA2/CA3
IPMI Base Address for SMM CA2/CA3
BMC Status OK
BMC Firmware Version M195.03A
IPMI Specification Version 2.0
BMC MAC Address 00:01:29:95:7D:96
ACPI SPMI Table <Enabled>
Boot Option Support <Enabled>
►BMC Configuration
►SDR List
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
IPMI Support
Enable or disable the IPMI functions. When it is set to "Enable", BMC detailed information will
only be valid after reboot.
BMC Warm Up Time
Insert a value from 0 to 240 (seconds) to specify the maximum waiting time from POST to
BMC ready.
ACPI SPMI Table
Enable or disable this field for IPMI driver installation.
Boot Option Support
Enable or disable IPMI boot option function.
Chapter 3
BIOS SETTINGS
Rev. 5.0
E n a b l e / D i s a b l e I P M I S u p p o r t .
Note: If changing to enable, BMC
detailed information only valid
after rebooting.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
34