Jumper Settings; Clear Cmos; Me Firmware Update - DFI PR610-C621 User Manual

X Jumper Settings

Clear CMOS

If any anomaly of the followings is encountered —
a) CMOS data is corrupted;
b) you forgot the supervisor or user password;
c) failure to start the system due to BIOS mis-configuration
— it is suggested that the system be reconfigured with default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Put a jumper cap on pin 2 and pin 3. Wait for a few seconds and set it back to its de-
fault setting, i.e. jumper cap on pin 1 and pin 2.
3. Plug the power cord and power-on the system.
3 2 1
„ 1-2 On: Normal (default)
User's Manual | PR610-C621
JP15
3 2 1
„ 2-3 On: Clear CMOS

ME Firmware Update

JP16 is used for updating the ME firmware.
1 2 3
„ 1-2 On: Normal (default)
Chapter 2
HARDWARE INSTALLATION
JP16
1 2 3
„ 2-3 On: Force ME Update
14