Table of Contents
Advertisement
Advanced
X
UEFI Device Manager
Configure UEFI device with option ROM, such as LAN card, etc.
InsydeH2O Setup Utility
Advanced
UEFI Device Manager
Exit BIOS Setup Utility and launch Device Manager !!
F1
Help
↑ /↓
Select Item
Esc
Exit
←/→
Select Item
Press "Enter" and "OK" to enter UEFI Device Manager setup page. More device settings can be
configured in the UEFI Device Manager, including LAN, Network Stacks, and etc.
Note:
Network Device will not be configurable in Device Manager if "Network Stack" is
disabled in the "Boot" menu.
User's Manual | PR610-C621
UEFI Device Manager Setting
[OK]
F5/F6
Change Values
F9
Setup Defaults
Enter
Select
SubMenu
F10
Save and Exit
X
Advanced
X
SIO NCT6112D
Configure Super I/O settings in this submenu. Scroll by moving the cursor up or down to reveal
more options.
Rev. 5.0
Advanced
COM1
Base I/O Address
Interrupt
COM2
Base I/O Address
Interrupt
WDT
Case Open Status
Case Open Alert
Clean Case Open Status
►Hardware Monitor
F1
Help
Esc
Exit
COM1 / COM2
Enables or disables the serial ports (COM). The following bracketed fields will only appear
when the port is enabled.
WDT
Enable or disable the Watchdog Timer (WDT) function. A counter will appear if you select to en-
able WDT. Input any value between 1 to 255 seconds.
▼ WDT = [Enable]
Counter
Set the timeout value of the WDT — 1-255 seconds.
Case Open Alert
Enable or disable case open alert.
Clean Case Open Status
Clean current case open status including alert.
InsydeH2O Setup Utility
<Enable>
<3F8>
<IRQ4>
<Enable>
<2F8>
<IRQ3>
<Disable>
Close
<Disable>
↑ /↓
Select Item
F5/F6
Change Values
←/→
Select Item
Enter
Select
SubMenu
X
Chapter 3
BIOS SETTINGS
Rev. 5.0
Configure Serial port using op-
tions: [Disable] No Configura-
tion [Enable] User Configuration
[Auto] EFI/OS chooses configu-
ration
F9
Setup Defaults
F10
Save and Exit
32
Advertisement
Table of Contents
