DFI PR610-C621 User Manual page 13

CPU Installing the CPU
X X
3. Place the CPU carrier on
top of the heatsink. Place
the triangular hole near the
Push Pin
mounting hole #1 of the
heat sink. Use the push-
pins around the CPU car-
rier to secure the CPU car-
rier onto the heat sink.
You will hear a distinctive
"click", indicating the CPU
carrier is correctly locked
into position.
Mounting hole #1 of the
heat sink (top view)
4. Slide the protective caps
open and detach them
from the board.
User's Manual | PR610-C621
Push Pin
CPU Carrier with CPU
(side view, bottom up)
Heatsink
(side view, bottom up)
Mounting hole #1 (bottom view)
Triangular hole
5. Align the triangular mark of
the CPU and CPU carrier to
the chamfer corner of the
CPU and heat sink socket.
Place the heatsink assem-
bly on top of the socket.
Use the T30 screwdriver
to install the assembly ac-
cording to the sequence of
the screws shown on the
label.
6. Connect the CPU fan's
power cable to the CPU fan
connector on the system
board.
Chapter 2
HARDWARE INSTALLATION
Chamfer corner of the
CPU and heatsink socket
CPU Fan
13