Sata Configuration - DFI PR610-C621 User Manual

Advanced
X

SATA Configuration

InsydeH2O Setup Utility
Advanced
SATA Configuration
►PCH SATA Configuration
►PCH sSATA Configuration
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
►PCH SATA Configuration
Press Enter to enter the sub-menu and configure on-board SATA 3.0 controllers.
►PCH sSATA Configuration
Press Enter to enter the sub-menu and configure the M.2 SATA storage device.
User's Manual | PR610-C621
Rev. 5.0
Enable/Disable SATA
Device.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
Advanced SATA Configuration
X X
►PCH SATA Configuration
InsydeH2O Setup Utility
Advanced
PCH SATA Configuration
SATA Controller(s) <Enabled>
SATA Speed <Auto>
Configure SATA as <AHCI>
SATA0 [Not Installed]
Port 0 <Enabled>
Hot Plug <Disabled>
SATA1 [Not Installed]
Port 1 <Enabled>
Hot Plug <Disabled>
SATA2 [Not Installed]
Port 2 <Enabled>
Hot Plug <Disabled>
SATA3 [Not Installed]
Port 3 <Enabled>
Hot Plug <Disabled>
SATA4 [Not Installed]
Port 4 <Enabled>
Hot Plug <Disabled>
SATA5 [Not Installed]
Port 5 <Enabled>
Hot Plug <Disabled>
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
SATA Controller(s)
Enable or disable the Serial ATA controller. This following fields will only be displayed when this
field is enabled.
SATA Speed
Select Serial ATA controller(s) speed — Auto, Gen1 (1.5 Gbit/s), Gen2 (3 Gbit/s) or Gen 3 (6
Gbit/s).
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
AHCI This option allows the Serial ATA controller(s) to use AHCI (Advanced Host Control-
ler Interface).
RAID This option allows the Serial ATA controller(s) to use UEFI, RAID, and Intel Rapid
Storage Technology.
SATA Port 0-5/Hot Plug
Enable or disable each Serial ATA port and its hot plug function.
Chapter 3
BIOS SETTINGS
Rev. 5.0
Enable/Disable SATA
Device.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
29